How to Take a Benelli Nova Apart
The Benelli Nova is a popular shotgun known for its reliability and durability. Despite its simplicity, taking apart the Nova can be a challenging task for inexperienced users. In this article, we will guide you through the step-by-step process of disassembling and reassembling your Benelli Nova.
Before You Begin
Before you start, make sure you have all the necessary tools and accessories. You will need a screwdriver, Allen wrench, and a rag or cloth. It is also recommended to have a set of spare parts and oils to maintain your shotgun in good condition.
Step 1: Remove the Safety Lock
To begin disassembling the Benelli Nova, start by releasing the safety lock. Located at the top of the grip, the safety lock must be turned counterclockwise to release. Remove the safety lock to give you access to the gun’s internal mechanisms.
Contents
**Disassembly of the Action and Top Tang**
To disassemble the action and top tang, follow these steps:
• Remove the top tang: Place your hand on top of the receiver and squeeze the tang, which is held by two pins. Release the pins by pulling the tang forward. Lift the top tang off the receiver, taking care not to lose the springs and springs that are inside.
• Remove the hammer: Place the hammer at the fully rearward position and press down on the hammer hook, which is located on the right side of the top tang. Release the hook by pushing it away from the top tang, then lift the hammer off.
• Remove the hammer sear: Use the hammer sear tool or an Allen wrench to loosen and remove the hammer sear screws. Gently pry off the hammer sear with a screwdriver.
**Disassembly of the Trigger**
To disassemble the trigger, follow these steps:
• Remove the trigger: Remove the trigger spring and remove the trigger screw. Then, lift the trigger out of the trigger housing.
• Remove the trigger connector: Use a screwdriver or Allen wrench to remove the trigger connector screws. Disconnect the trigger connector and set it aside.
**Disassembly of the Recoil Spring Assembly**
To disassemble the recoil spring assembly, follow these steps:
• Remove the recoil spring: Release the recoil spring by squeezing and lifting the recoil spring lever, which is located at the rear of the stock.
• Remove the guide rod: Remove the guide rod screws and take off the guide rod, exposing the recoil spring retainer.
**Reassembly of the Gun**
To reassemble your Benelli Nova, follow the steps in reverse:
**Assembly of the Action and Top Tang**
• Install the recoil spring retainer: Take the recoil spring retainer and slide it back over the guide rod. Secure with guide rod screws.
• Reinstall the guide rod: Slide the guide rod into the stock, taking care not to damage any surrounding components.
• Install the recoil spring: Use a screwdriver or pliers to push the recoil spring back into the receiver.
• Install the trigger and trigger connector: Put the trigger and trigger connector together, ensuring they fit securely.
• Install the top tang: Place the top tang over the receiver pins, and push until seated.
• Install the safety lock: Place the safety lock at the top of the grip and tighten the screw until secure.
**Troubleshooting Tips**
When taking apart your Benelli Nova, you may encounter a few issues. Here are some troubleshooting tips to keep in mind:
• Sticking parts: If the trigger or hammer sear seems stuck, try soaking it in some gun cleaner to loosen it up. Gently clean the surfaces, and use a screwdriver or pliers to wiggle it loose.
• Missing springs: It is easy to lose or misplace the springs while taking apart your Benelli Nova. Check the components closely and keep track of your parts.
• Damage or wear: Inspect all components carefully for any damage or wear. Keep spares on hand for your Benelli Nova.
By following these steps, you should be able to take your Benelli Nova apart safely and effectively. Remember to handle your shotgun carefully to avoid accidental discharge. **Always handle firearms safely, and ensure you follow the manufacturer’s instructions.
