How to adjust a Bushnell rifle Scope?

How to Adjust a Bushnell Rifle Scope?

Introduction

Adjusting a Bushnell rifle scope can be a daunting task, especially for beginners. However, with the right guidance and patience, anyone can achieve precise and accurate adjustments to their scope. In this article, we will take you through the step-by-step process of adjusting a Bushnell rifle scope to ensure you get the most out of your shooting experience.

Understanding Your Bushnell Scope

Before we dive into the adjustment process, it’s essential to understand the basics of your Bushnell scope. Here are some key components to familiarize yourself with:

• Turrets: These are the adjustable knobs located on the top of your scope. They control the elevation (up and down) and windage (left and right) of your scope.
• Elevation and Windage Knobs: These knobs have markings or lines to indicate the amount of adjustment made. Some scopes have a 0.25 MOA or 1/4 MOA adjustment, while others may have 1 MOA or 1 inch increments.
• Parallax Adjustment: This is the adjustment knob located on the side or front of the scope, usually marked with a ∞ (infinity) or Parallax Free label. This adjusts the scope to focus on the target at a specific distance.

Step-by-Step Adjustment Process

Adjusting a Bushnell rifle scope is a process that requires patience and attention to detail. Here’s a step-by-step guide to help you achieve accurate adjustments:

Elevation Adjustment

1. Determine your zero distance: Establish your zero distance by shooting a group at a known distance (e.g., 100 yards). Record the elevation knob setting at which your scope is zeroed.
2. Make adjustments: If you need to make elevation adjustments, turn the elevation knob in the appropriate direction (up or down). For every 1 MOA of adjustment, your bullet will travel approximately 2.87 inches at 100 yards.
3. Re-zero: After making an elevation adjustment, re-shoot your group at the same distance and record the new elevation knob setting.

Windage Adjustment

1. Determine your zero point: Use your windage knob to adjust your scope to center your reticle over the target.
2. Make adjustments: If you need to make windage adjustments, turn the windage knob in the appropriate direction (left or right).
3. Re-check: After making a windage adjustment, re-check your scope’s alignment by looking through the scope and ensuring the reticle is centered over the target.

Parallax Adjustment

1. Determine your parallax distance: Identify the distance at which your scope’s parallax adjustment is set to ∞ (infinity).
2. Adjust the parallax: Adjust the parallax knob until your scope is focused on the target at the specified distance.
3. Re-check: After making a parallax adjustment, re-check your scope’s focus by looking through the scope and ensuring the image is clear and sharp.

Important Tips and Considerations

• Start with small adjustments: When adjusting your scope, make small adjustments (1/4 MOA or less) and re-zero after each adjustment to avoid over-shooting or under-shooting your target.
• Use a laser bore sighter: A laser bore sighter can help you get a more accurate starting point for your scope adjustments.
• Keep your scope clean: Regularly clean your scope to prevent dirt and debris from affecting its performance.
• Use a bubble level: A bubble level can help you ensure your scope is properly aligned with your rifle.

Table: Bushnell Scope Adjustments

Conclusion

Adjusting a Bushnell rifle scope requires patience, attention to detail, and practice. By following the step-by-step guide outlined above, you’ll be well on your way to achieving precise and accurate adjustments to your scope. Remember to start with small adjustments, use a laser bore sighter, keep your scope clean, and use a bubble level to ensure optimal performance. With practice and dedication, you’ll be hitting your targets like a pro!